Badland Stoves Let us help you reduce your heating costs!
Phone us -- 701.721.3483
Products Products Benefits
Available in 5 Colors
Black (No Trim)
Regal Blue Blush
Hunter Green
Stove Specifications and Information



Installation:
Install in accordance with manufacturer's instructions. See below for home installation requirements.
Heating Area:
Heating area will vary depending upon floor plan, heat loss and geographic location of home, stove venting configuration and climate

Shipping Weight:
350 lbs.

Electrical:
120 volt AC (all loads shown are combined)
-Normal Operating Mode: 1.6 Amps
-Ash Dump: 4.6 Amps
-Ingition Mode: 8 Amps

Tested and Listed By:
OMNI-Test Laboratories Inc.

Tested To:
ASTM E 1509, ULC C1482

Dimensions:
height: 33" width: 28" depth: 30"

Deluxe Trim Options:
Nickel Plated or 24k Gold Plated (Doors & Vents)

Fuel:
Multi-fuel System:  Dry shelled corn, Wood pellets (recommended maximum size approximately ¼ in. diameter x ½ in. long), or “BIXBY” certified Blue or Green Biomass pellets.  The use of “Cracked Corn” in not recommended due to feed and burn issues.

The use of lower quality corn with foreign material (cobs, stones, or other material) may cause feed issues.  When loading the corn into the hoper, remove as much foreign material as possible
Because the Bixby Stove has the ferris wheel feeding system it is not necessary to purchase cleaned corn. In the picture below notice the chaff is left at the bottom of the hopper--the ferris wheel will not pick it up.

This reduces noisy augers and the chances of your stove shutting down because of a jammed augger. The ferris wheel system reduces your corn cost as it is not necessary to have the corn cleaned before you put it in the stove.

Fuel Burn Rates:

Level
Approx. Feed Rate lbs/hr (kg/hr)
Time Between Ash Dump
Approximate Hours / Full load
1
1.8 (0.8)
21hrs
57
2
2.1 (1.0)
17.5 hrs
48
3
2.3 (1.1)
16 hrs
43
4
2.6 (1.2)
14 hrs
38
5
3.0 (1.4)
12.5 hrs
34
6
3.5 (1.6)
10.5 hrs
29
7
3.9 (1.8)
9.5 hrs
26
8
4.6 (2.1)
8 hrs
22

Home Installation:
Home owner installation is easy!  Here is a list of recommended tools required to complete your Bixby installation.   

  • 6 inch Level
  • Drill with socket adapter to install sheet metal screws
  • Drill bits , to pre drill screw holes
  • Hammer
  • Screwdriver
  • Tape Measure
  • Silicone Calking, Exterior sealant
  • High Temperature Caulking (500F)
  • Reciprocating Saw or 5 in hole saw
  • Stud finder
  • Adjustable wrench
  • Eye protection and Glove

 
 

701.721.3483    
                            Home | Products | Specifications | Price List | Benefits | Fuel Comparisons | Contact Us
Copyright ©2005    Site Design by